![]() ![]() Once the glue has dried you can now sand over your floor and take off any high spots that may be left due to any wooden strips sticking above floorboard level leaving you with a smooth and gap free floor.Īs you may have guessed, how well the joints blend in with the rest of your floor will depend on the colour and shade of the wood that you use. Now using a soft mallet, hit the strip of wood down into the gap to create a air and dust tight seal.Ĭontinue this process for the whole of your floor until all of the gaps have been filled and then leave for an hour or so for all of the glue to dry. What you have to do is cut strips of wood ever so slightly larger than the width of the gap between each of the floorboards and the same depth and then apply some glue (wood glue or similar) to each of the insides of the boards. This method, although a little tricky and time consuming is probably the best and if done with care can give an amazing finish. This will need to be done before you sand your floor! The joint will sand down and look very similar to the board surface but because of the PVA content, will not stain in the same way. Leave until PVA is dry and then go over the joint with a small electric sander. Use the handle of a screwdriver or scraper for this. Push the sawdust down into the PVA so it is level with the top of the board. This will only work with tongue and groove flooring where the PVA can "sit" on the tongue. ![]() ![]() If you are in the process of sanding and re-finishing your floor, after the initial sanding (you should save as much sawdust as possible in a container) you can apply a layer of PVA adhesive to the gap. Unless you have a special foam applicator gun the flow of this stuff is impossible to control in the precise way needed to fill gaps this small. It will cost you a fortune and you will be forever cleaning up the mess. We have also seen a suggestion, on another website, to use expanding spray foam to fill boards, Do not do this. This of course will wear down in time and with several applications but in the first instance, whatever we show you here will show up when the floor is finished so please do not write in telling us so. When you apply your oil, wax or varnish finish to the floor your filler will not take the application in the same way as the timber does. If you are filling gaps in your floorboards you may also be interested to see our replacing a timber floor project, our sanding a timber floor project and timber floor finishes project.įilling or sealing gaps in floorboards is a very popular topic on Diydoctor and although there are several ways to do this it must always be remembered that, unless you are painting the floor, or are staining it with some very dark stain, the filling method you use will always show up. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |